January 2013
Page 8 of 15
Fitting/Connecting the ECONTROL Wall Controller
The ECONTROL uses low voltage to communicate via the RJ control cable supplied. The
controller should be located in a suitable place for easy access.
RJ plug from controller to be
fitted to either socket
Open the ECONTROL.
Lead the control cable through an opening
in the back casing.
Fix the back casing to the wall and fasten
the cable, leaving 9cm protruding.
If required set the DIP switches in the front
casing (refer to pages 9 and 12).
Plug the control cable into the socket in the
front casing.
Re-attach the front casing to the back
casing.
The other end of the control cable should
be connected to either one of the sockets
on the side of the heater.
The other socket on the side of the heater
may be used to Master/Slave two or more
cassette heaters.
Always ensure the control cable is safely
secured.
