Biasi Activ A 30C, User Manual And Installation Instructions

Page: 18 / 88

- 18 -
USE
INSTRUCTIONS FOR USE
controlled by the ambient thermostat and
the other by the remote control it is possible
to have two different heat delivery tempera-
tures.
The heating temperature of the zone valve
controlled by a thermostat is configured on
the boiler control panel using keys 17 and
18 Fig. 2.9.
The heating temperature of the zone valve
controlled by remote control is configured
using the heating temperature regulation
keys on the remote control.
Setting the heating time brackets for
zone 1 (room/TA zone)
In order to satisfy a heating request, both
the TA and the clock must be activated.
The second zone on the other hand is man-
aged independently from the remote (so it
already has its own time brackets).
N.B.: In the case of a single zone controlled
by TA and boiler clock (where programmed
with time brackets), in order to have a heat-
ing request, both the TA and clock consents
must be obtained.
N.B.: The scheduling of the heating brack-
ets does not affect possible requests for
system antifreeze (AF) which are satisfied,
irrespective of the time bracket set.
To set the time brackets:
Enter ”programming mode” by holding down
keys 18 and 19 for 5 seconds (Fig. 2.14)
until the LCD display indicates the symbols
shown in Fig. 2.13.
Fig. 2.13
Fig. 2.14
11
12
13
14 15
16
17
18
19
Press keys 11 or 12 (Fig. 2.14) to select the
individual day (1)(2)(3)(4)(5)(6)(7) or if you
want groups of days with the same time
bracket scheduling, hold down key 11 until
groups (1÷5), (1÷6), (1÷7), (6÷7) are dis-
played (flashing), then confirm by pressing
key 14.
The days or groups of days selected will be
indicated via the related icons on the left
side of the LCD Fig. 2.15.
Fig. 2.15
Press key 14 followed by key 18 to program
the first ignition period (PI on), confirm by
pressing key 14, the subsequent off time (PI
off) is already prompted with an additional
15 minutes (minimum programming inter-
val); to modify this, press key 14 followed