Configuring a RED-1 from its configuration menu
This article explains how to configure the
, from the remote's own configuration menu.
Accessing the configuration menu
An on board configuration menu can be enabled by briefly shorting the two pins of the
"locksmith"
header found in the
bottom right corner of the printed circuit board.
Edit device ID
For the RED-1 remote controller to communicate with the corresponding block in an Audia/Nexia system, the ID of the
remote must match that of the corresponding block. Multiple remotes can have the same ID as a single block in the
Audia/Nexia configuration. To name the unit, scroll to the ID tag icon and press the select button. Then, use the scroll
and select buttons to choose and set the desired characters.
Edit network settings
The default network settings of the RED-1 controller allows it to be discovered by an Audia or Nexia device that also has
default settings. To edit the network settings, scroll to the network icon and press the select button. From there, you can
navigate to each individual parameter and edit as needed.
Copyright 2013-2020 Biamp Systems
http://support.biamp.com/
1
