Stereo Signals
Connect the corresponding signal wires to the “L” and “R.” Connect the ground wire to “GND.”
Adjusting Input Volume
Each Qt control module is pre-configured to mute any auxiliary input upon shipment. The volume level of each input is
controlled per zone through the front panel of the control module or using the MCS software web GUI of the Qt 300/600.
Navigate through the front panel LCD to the desired Zone and Input, and adjust the volume using the 'Up/+' and 'Down/-'
levels.
Troubleshooting
If the volume is turned up on each zone and if the volume is still too low, you will need to isolate the problem to the cable
or auxiliary device. First, check to ensure the volume on the audio source (ie. volume on an iPod) is turned to its
midpoint. Then, check to ensure the cable was prepared correctly. The correct method for creating a cable is as follows:
1. Take a 1/8” stereo cable or RCA cable that connects to the music source and strip back the main insulation
1/2” to expose the bare wire, including the red and white insulated wires.
2. Separate the insulated conductors from the exposed outer strands. This is the ground
3. The insulated conductors are the left and right signals and will correspond to the “L” and “R” ports on the
control module. The exposed outer conductor will connected to the "GND".
Copyright 2013-2020 Biamp Systems
http://support.biamp.com/
4
