Disinfection, Cleaning and Maintenance
17
10.
Replace actuator, clevis pins and cotter
pins.
Follow proper direction
(see
drawing).
Make sure the actuator wire is
placed down next to the battery.
11.
Replace the base cover.
Important: Make sure the wires are out of
the way and not squeezed.
Charger Fuse Replacement
If the charger light does not illuminate when
THE LIFT IS PLUGGED IN, do the
following steps:
1.
Check to make sure the power cord is
correctly plugged into the charger and
the wall.
2.
If the light still does not work, plug the
LIFT into a different outlet in a different
area to ensure that the outlet is working
properly.
3.
Pull the power cord out of the charger.
Under the socket for the power cord,
there is a drawer or magazine where
there are fuses. Pull the drawer out
gently. Pull the burnt fuse out of the
drawer that is next to the charger (see
diagram below) and discard it. Take the
replacement fuse and place it in the same
slot where the burnt fuse was. Slide the
drawer back into the charger. Plug the
power cord into the charger. Check for
the battery charger light indicator.
4.
If the light does not illuminate, contact
your local dealer or representative for
assistance.
Replace the fuse with the following:
Fuse in North America: GMC 0.5A 250 V
(when input is 120 Vac) Product
# C8FGMC0.5.
The fuse may also be ordered through your
local dealer or representative.
Boom Actuator Replacement
1.
Remove the bolt and plate (with phillips
screwdriver) that secures the actuator
power cord under the control box.
2.
Remove the clevis pin from the actuator
on the top and bottom of the actuator.
