Page 8
NEDSP1062-KBD Operating Manual
Figure 4.
Keyboard mounting 2.
If the enclosure is too
thin to incorporate a
countersunk screw
(such as fitting into
sheet metal) then it can
be retained by a
instrument head
screw.
The label needs to be
cut out to allow the
screw to pass through
from the outside. This
can be easily achieved
by applying the label to
the panel, then carefully cutting around the screw hole,
with a sharp knife. Again do not over tighten the screw.
Nut &
washer
Front panel
label
keyboard
Retaining
screw
Front
panel
1.5
Sounder mounting.
Cut a small piece of the
self adhesive foam
(supplied) to mount the
sounder.
Do not cover the small
hole in the face of the
sounder.
For best results mount
the sounder where it
can radiate sound to
the outside the case,
for example on an air
vent.
Figure 5. Sounder mounting
Sounder
Backing paper
Backing
paper
Self adhesive
foam
Case
Keep this
hole clear
Cut hole
for screw
1.
Introduction.
