28
LK700WS v.2
SHUTTING DOWN THE TREADMILL
The treadmill can be shut down by turning off the power, which will not damage the treadmill.
COMMON ERRORS AND SOLUTIONS
PROBLEM
POSSIBLE CAUSE
SOLUTION
Treadmill does not work
a. Not connected to power supply
Plug into socket
b. Safety key not inserted
Insert safety key
c. Signal not being received
Check connections to lower control board
d. Treadmill is not on
Switch on
e. Fuse is broken
Change the fuse
Belt does not run properly
a. Running belt needs lubrication
Lubricate board with silicon
b. Running belt is too tight
Adjust running belt
Belt is slipping
a. Running belt is too loose
Adjust running belt
b. Motor belt is too loose
Adjust the motor belt
1. ELECTRONIC ERROR: 01
A: E01: The lower control board is having difficulty communicating with the console.
B: Solution: Check the 4 lines that connect the console and see if they are connected properly.
Check for pinched, damaged, or loose cables. Secure the cable connections if they are loose,
replace the cables if damaged.
2. ELECTRONIC ERROR: 02
A: E02: The lower control board does not detect motor voltage.
B: Solution: Check the + and - connection wires. Make sure they are connected to the + and -
terminals and that the wires are not damaged.
3. ELECTRONIC ERROR: 03
A: E03: No speed signal is detected
B: Solution: Check to see if the speed sensor is connected securely. Check to see if the sensor
is in line with the magnet on the motor and the gap between them is 3-5mm. If the problem
persists, change the speed sensor.
4. ELECTRONIC ERROR: 05
A: E05: Motor current is over limited.
B: Solution: Visually inspect the motor to see if it turns freely. Make sure that there is nothing
obstructing the movement of the running belt on rollers. If the problem persists, replace the motor.
5. ELECTRONIC ERROR: E07
A: E07: Safety key is not detected.
B: Solution: Make sure that the safety key is installed. If problem persists, replace the safety key.