BH H853, Instructions For Assembly And Use

Page: 18 / 46

18
the front post (2) and attach the clamp
cover ((91) for H853 and (94) for
H854B), using the bushing (90) and
the knob (52), Fig.11.
9. FITTING THE MONITOR.-
Remove the pre-assembled screws
(82) from the monitor (18). Connect
the wires (58) and (60) with the wires
of the monitor (18), Fig.12. Place the
monitor (18) on top of the plate on the
front post (2), as shown in Fig.12,
making sure not to snag any of the
cables and refit the screws (82).
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (A) up or down, as
shown in Fig 13.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (B),
Fig.14, to make it easier to move. The
wheels located at the front of your unit
make it easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.14. Store your unit in a dry place,
preferably not subject to changes in
temperature.
MAINS CONNECTION H854B.-
Insert the jack (m) on the transformer
(91) into the connection hole (k) on the
main body (bottom, front of the
machine) and then plug the
transformer into a 220 V mains supply,
Fig 15.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE