6
English
FITTING THE BATTERIES.-
This monitor uses two 1.5 volt
ALKALINE BATTERIES. To fit the
batteries, remove the rear cover on
the monitor, Fig. 1, and carefully insert
the two “R-6” type batteries into the
battery compartment (A) making sure
that the battery’s polarity is correct
(matching the battery’s «+» terminal
with the «+» sign inside the battery
compartment, and the «-» terminal
with the «-» sign). Close the cover, as
shown in Fig. 1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
The monitor will switch itself off
automatically if the unit remains
motionless for 4 minutes.
Important.
Discarded batteries must
be deposited in special containers,
Fig. 2.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit provides
simultaneous read-outs of speed,
distance, exercise time, calories burnt
and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
A. SCAN FUNCTION.-
In SCAN mode the computer
continuously scans and displays all of
the functions during exercise. The
function being displayed will flash on
and off.
To select the SCAN function:
1
. The monitor starts in SCAN mode
as soon as exercise begins or if any
key is pressed, the main screen will
display TIME, SPEED, DISTANCE,
CALORIES, PULSE RATE values
every 6 seconds
.
2
. Press the MODE key and this will
cancel the SCAN function.
B. DISTANCE FUNCTION.-
This function counts up or down in
steps of 0.1 km/ml, up to a maximum
of 999.9 km/ml. Pressing the MODE
key for more than two seconds will
reset all of the values.
1
. Press any key to switch the monitor
on.
2
. Press the MODE key to start the
small DIST (DISTANCE) window
flashing.
3.
Press the SET keys to select the
distance.
4.
Begin the exercise and the distance
value will begin the countdown, when
it reaches zero it will beep for 8
seconds, advising you that the
selected distance has been covered,
the distance value will then start
counting upward.
Summary of Contents for H267N
Page 2: ...2 Fig 1 Fig 2 Fig 3 ...