BH Fitness
•
20155 Ellipse
•
Foothill Ranch
•
CA
•
92610
www.
%+)LWQHVV86$
.com
•
Phone 949-206-0330
•
Fax 949-206-0013
22
SECTION 6
PREVENTIVE MAINTENANCE
The running belt can shift to one side or simply
‘
skid
over
’
when running. Run the machine at 3 mph for a
few minutes to determine which side the belt is
drifting towards, left or right. Center the belt using
the Torque wrench.
If the belt is drifting left.
i) Turn the treadmill off and unplug from the machine.
ii) Tighten the left hexagonal head socket a ¼ turn
(clockwise).
iii) Loosen the right hexagonal head socket a ¼ turn
(counterclockwise).
iv) Run the belt at 3 mph again for a few minutes.
If the belt drifts to the left, repeat steps.
If the belt is drifting right.
i) Turn the treadmill off and unplug from the machine.
ii) Tighten the right hexagonal head socket a ¼ turn
(clockwise).
iii) Loosen the left hexagonal head socket a ¼ turn
(counterclockwise).
iv) Run the belt at 3 mph again for a few minutes.
If the belt drifts to the right, repeat steps.
Once the running belt has been adjusted, closer to
the center, the treadmill can be powered on again.
WARNING!
Do not use cleaner under the running belt.
i) Use Torque wrench to loosen the hexagonal head
socket in the end caps. Remove excessive
accumulations of dust, dirt, and other substances
from running deck. ONLY use a clean soft cloth.
ii) Gently pull up the side of the running belt.
Dispense a thin layer of the lubricant on deck, and
spread evenly. DO NOT over lubricate.
iii) Center the belt (using the instructions above), and
tighten the hexagonal head socket.
Check belt condition and if necessary adjust using
the instructions above.
Rear Roller
Hexagonal
Head Socket
Use Torque wrench
to turn Hex Head
Socket
For home use:
4 Miles or less / hr = lube every 1 year
4~8 Miles / hr = lube every 6 months
8 Miles or more / hr = lube every 3 months
T S 1
It is recommended that the deck be lubricated
regularly according to the frequency of usage.
Refer to the suggested schedule in the table below .
