5
English
FITTING THE BATTERIES.-
This monitor uses two 1.5 volt
ALKALINE BATTERIES. To fit the
batteries, remove the rear cover on
the monitor, Fig.1, and carefully insert
the two “AAA” type batteries into the
battery compartment making sure that
the battery’s polarity is correct
(matching the battery’s «+» terminal
with the «+» sign inside the battery
compartment, and the «-» terminal
with the «-» sign). Close the cover.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important.
Discarded batteries must
be deposited in special containers,
Fig.2.
FITTING THE ELECTRONIC
MONITOR.-
Fit the monitor (m) into the boss on
the bracket (n), as shown in Fig.3,
connect terminal (F) on the middle
cable to terminal (E) for the monitor,
Fig.4, then connect terminal (h) on the
middle cable to terminal (k) for the
feedback cable.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit provides
simultaneous read-outs of speed,
distance, exercise time, calories burnt.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes, with the screen
displaying the temperature.
A: TIME SETTING.-
After installing the batteries, the time
window will blink in the display.
Press the key to set the hours, wait 5
seconds and the minute window will
start to blink; press the key to set the
minutes.
B: TIME FUNCTION.-
This function counts up in steps of one
second, up to a maximum of 99:00
minutes.
Pressing the key for more than two
seconds will reset all of the values
except time.
1. Press any key to switch the monitor
on.
C: DISTANCE FUNCTION.-
This function counts up in steps of
0.01 km/ml, up to a maximum of 99.99
km/ml.
Pressing the key for more than two
seconds will reset all of the values
except time.
1. Press any key to switch the monitor
on.
