BH FITNESS G152X, Instructions For Assembly And Use

Page: 38 / 73

38
FITTING THE GLUTEAL CABLE.-
20.- Pass one end of cable (66),
Fig.19, coming out of pulley D1,
through pulleys E1 and F1, take the
carabiner (60) and attach it to push
bar (12), Fig.19.
Pass the other end of cable (66)
through pulley B1 and A1 and use
carabiner (60) to attach it to the
crossbar (8), Fig.19.
FITTING THE BACKREST.-
21.- Take the backrest (90) and
position it against the central mast, as
shown in Fig.20.
Now use the bolts (99) and washers
(118) to secure the backrest Fig.20.
FITTING THE GLUTEAL
BACKREST.-
22.- Take the backrest (89) and
position it against the central mast, as
shown in Fig.20.
Now use the bolts (99) and washers
(118) to secure the backrest, Fig.20.
FITTING THE BACKREST.-
23.- Take the backrest (92) and
position it against the central mast, as
shown in Fig.21.
Now use the bolts (99) and washers
(118) to secure the backrest, Fig.21.
FITTING THE SUPPORT
COVERINGS.-
24.- Take the coverings (91) and position
them on the abdominal arms, Fig.21.
Fit the bolts (100) with their washers
(130) and tighten securely.
FITTING THE PANELS.-
25.- Position the left and right
protection plates (95 and 96) onto the
main frame (5), fitting the plate wedge
into the accommodating groove in the
base, then tighten screws (98) slightly
in the upper part as shown in Fig.22.
FITTING THE WEIGHTS.-
26.- Fit the guide post (38) along with
washers (75) and the bottom weight
stops (76) as shown in Fig.23.
27.- Next, place the weights (43), onto
the guide post as shown in Fig.23, in
correct alphabetical order with the
letters facing the front of the machine,
beginning with the letter “L”.
28.- Now take the weight selector tube
(44), Fig.23, and attach the holding
collar (46) for the first weight and
insert the lockpin (45). Fit the last
weight (43) onto the bars (38).
Fit the bushes (69) tighten the bolts
(106) for the guide post (38) to the
main body (5), as shown in Fig.23.
FITTING THE CABLE SYSTEM.-
29.- First check that the steel cables
are correctly fitted into the pulleys that
are supplied prefitted, following the
arrows in Fig.13.
The weights have already been
fitted into their housing in the previous
assembly step.
Lift the first weight (42) and fit the
weight selector post (39), as shown in
Fig.24A.
Screw bolt (63) into the selector
post (39), when it is screwed in, lower
the weight so that it rests on the other
weights.
Insert the weight selector pin (44)
into the selector post (39), Fig.23, and
tighten nut (U) securely, Fig.24A.
Next, attach one end of cable (65)
to the left arm plate for the Butterfly
exercise, Fig.24B, fit bolt (103) with
washers (119) and nut (125).