BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Operation
Install and remove the battery pack
Fit a battery pack to the angle grinder and make sure that it is pushed all the way into the battery
holder
Caution
•
Always switch off the tool before installing or removing of the battery cartridge.
•
Hold the tool and the battery pack firmly when installing or removing battery cartridge. Failure to
hold the tool and the battery cartridge firmly may cause them to slip off your hands and result in
damage to the tool and battery cartridge and a personal injury.
•
To remove the battery cartridge, slide it from the tool while sliding the button on the front of the
cartridge.
•
To install the battery cartridge, align the tongue on the battery cartridge with the groove in the
housing and slip it into place. Insert it all the way until it locks in place with a little click. If you can
see the red indicator on the upper side of the button, it is not locked completely.
Before operation
Fitting and removing the battery pack. Slide the battery into the handle
until it engages.
To remove the battery, hold down the battery pack release button (A)
and pull the battery pack out of the handle.
Charging the battery pack
Slide the battery pack onto the charger.
Connect the charger to a suitable mains socket. The charger may
become warm and buzz slightly during charging. This is normal and
does not indicate a fault.
When the charger is plug in, the green light will light up.
When the battery pack is charging the red light will blink.
When the battery pack is fully charged, the red light will stop blinking
and remain lighted up.
After charging, unplug the charger from the wall outlet.
The battery pack can become warm if the machine is subject to heavy use.
Always allow the battery pack to cool down before re-charging.
