SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
F
5
6
e
s
s
a
r
t
S
r
e
s
u
k
r
e
v
e
L
ax +49 (0) 2191 / 46438-40
e
d
.l
h
a
t
s
w
s
@
o
f
n
i
:l
i
a
M
-
E
d
i
e
h
c
s
m
e
R
7
9
8
2
4
-
D
Instruction Manual
BGS technic KG
Bandwirkerstr. 3
42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Art. 1709
Clutch Aligning Set
GENERAL INFORMATION
This Clutch Aligning Set is made for easy and perfect centering of the clutches. The set includes two
alignment mandrels for clutch hub inner diameter 15 – 19 mm and 20 – 26.6 mm.
APPLICATION
Select the appropriate centering mandrel.
Push the centering mandrel into the clutch hub.
Spread the centering mandrel by turning the knurled screw
clockwise. The centering mandrel must be seated free of
clearance in the clutch hub and must be easily moved
axially.
Install the clutch disc with clutch pressure plate.
Tighten slightly the mounting bolts from clutch pressure
plate. Clutch disc must be able to move radially.
Push the centering mandrel further toward the engine.
The cone (at front of centering mandrel) will be pressed
into the crankshaft bore and centered the clutch disc. At
the same time turn the knurled screw clockwise for fixing
the centering mandrel in the clutch hub.
Press the centering mandrel with clutch disc toward the
engine and evenly tighten the mounting screws of clutch
pressure plate succession. Tighten the screws at the end
with the specified torque.
Solve centering mandrel by turning the knurled screw
counterclockwise and remove the centering mandrel.
