BGE BGO1402-20, Instruction Manual

Page: 11 / 13

6. Wrong thermostat setting
7. Temperature sensor
override
8. Fuse damaged
6. Calibrate the thermostat by
setting it higher than
ambient temperature
7. 1)Wait at least ten minutes
then try to run ignition
again
2)Contact the technical
service center
8. Contact the technical service
center
Motor/Pump
runs but the
flame does not
start 1. No fuel
2. Ignition device is dirty
3. Fuel filter is dirty
4. Nozzle is dirty
5. Photocell
is dirty,
damaged or installed
improperly
6. Foreign substances
present in the tank
7. Electrodes are used up or
placed at an improper
distance
1. Turn off the generator,
refill the fuel tank then
restart the generator
2. Contact the technical
service center
3. Clean the filter using clean
fuel
4. Contact the technical
service center.
5. Contact the technical
service center.
6. Empty and refill the fuel
tank with clean fuel
7. Contact the technical
service center.
Fan blocked or
spins
too
slowly
1. Engine damaged 1. Contact the technical
service center