BFT Americans Prime, Installation & User Manual, Page: 10 / 21

P a g e | 10
80?# When ? = 1, this function is disabled. Set to 2 to enable. N/A
Caller ID features
72number#
Store caller ID number. Max 14 digits. Only last 6 digits
compared.
N/A
73number# Delete caller ID number. N/A
73*# Delete all caller ID numbers N/A
Service & diagnostic messages (no passcode required for these!)
*20# Check reception level 1-31 (no passcode needed) N/A
*21#
Check stored numbers. O = dial out number. I = dial in number.
E = end of message. (no passcode needed)
N/A
*22# Check input status and relay status. (No passcode needed) N/A
*23# Call log of last 20 Caller ID numbers N/A
Restore Defaults
999# Send with passcode string to clear all programming. N/A
Controlling Relays when used as Alarm Dialler
If the alarm input is used to trigger the unit and call a phone, the user can answer the call and
control the relays with DTMF touch tones on their phone as follows..
Control by SMS
This device
allows the user to send SMS commands to control the relays as follows…
1234# 1 # - Relay 1 momentary trigger.
1234# 2 # - Relay 1 latch ON or hold ON.
1234# 3 # - Relay 1 unlatch or switch OFF.
1234# 4 # - Relay 2 momentary trigger.
1234# 5 # - Relay 2 latch ON or hold ON.
1234# 6 # - Relay 2 unlatch or switch OFF.
Check if door or gate is open or closed
1
2 3
4 5 6
7
8 9
0
*
#
Relay 1
Press 1 to momentary trigger
Press 2 to Latch or hold open
Press 3 to unlatch or close.
Send the SMS as shown, and the unit will reply showing the status
of the input limit switch (if used), and the relay..
This example shows that the input sensor is in OPEN state. Relay 1
is OFF and Relay 2 is latched ON.
TIP : If there is not a physical limit switch fitted to the door or gate,
then the status input will always show OPEN.
*22#
OPEN,
Relay 1=
OFF,
Relay 2 =
ON
Relay 2
Press 4 to momentary trigger
Press 5 to Latch or hold open
Press 6 to unlatch or close