BFI Automation 3001D, Original Operating Instructions

Page: 30 / 49

Transport, installation and connection
4-4
4.7 Connection
4.7.1 Electrical connection
Danger to life caused by electrical current !
The safety instructions and local safety regulations have
to be observed during connection !
For connection data, please refer to the chapter titled
"Technical data" as well as to the following terminal dia-
gram.
Ensure that the available supply voltage complies with the
voltage indicated on the type plate (24 VDC).
Prior to connection, check the device and the connecting
cables for visible damage.
Push the flame amplifier into the 19" rack and connect the
connecting cable up to the rack.
Various connection possibilities are available:
•
Backpanel R (screw terminal on the rear)
•
Backpanel F (screw terminal on the front)
•
Pin connector
- Flat-Pin 2.8 mm
- Maxi-Termipoint
- wire wrap
Prior to the connection of the flame sensor to the flame
amplifier, observe the separate operating instructions of
the flame scanner !