ET188
13
TREADBELT TRACKING ADJUSTMENT:
The performance of your treadmill is dependent on the frame running on a reasonably level
surface. If the frame is not level, the front and back roller cannot run parallel, and constant belt
adjustment may be necessary.
The treadmill is designed to keep the tread-belt reasonably centered while in use. It is normal
for some belts to drift near one side while the belt is running with no one on it. After a few
minutes of use, the tread-belt should have a tendency to center itself. If, during use, the belt
continues to move toward one side, adjustments are necessary.
TO SET TREADBELT TRACKING:
A 6 mm Allen wrench is provided to adjust the rear roller. Make tracking adjustments from the
left
side only. Set belt speed at
approximately 2 to 3 mph. A small
adjustment can make a dramatic difference.
Turn the bolt only a 1/4 turn and wait a few
minutes for the belt to adjust itself.
Continue to make 1/4 rotation turns until
the belt stabilizes in the center of the
running deck. The belt may require
periodic tracking adjustment depending on
use and walking/running characteristics.
Some users will affect tracking differently.
Expect to make adjustments as required to center the tread-belt. Adjustments will become less
of a maintenance concern as the belt is used. Proper belt tracking is an owner responsibility
common with all treadmills.
ATTENTION:
DAMAGE TO THE RUNNING BELT RESULTING FROM IMPROPER TRACKING /
TENSION ADJUSTMENTS IS NOT COVERED UNDER THE WARRANTY.
MAINTENANCE MODE:
If you want to set the Speed and Distance to Metric or if there is a problem with the speed and
you would like to perform the calibration procedure, use the Maintenance Mode. To enter
Maintenance Mode press, and hold for 5 seconds, the Start, Stop and Mode keys while
installing the safety key.
•
The dot matrix display will now be showing the word SET
•
The Speed window will show a number for the roller size, press the up and/or Down key
to adjust the roller size. The roller size for the ET188 is
1.8
•
The Speed window will also display the setting for M (miles) or Km (Kilometers). Press
the Stop key to change between M and Km.
•
To run the calibration procedure, press the Start key.
o
The display will show a number for the lowest speed setting (for miles the
number should be 0.5). Adjust the low speed setting and press Start.
o
The display will show a number for the top speed setting (for Miles it should be
8.0). Adjust the top speed setting and press Start to begin calibration.
o
The belt will start automatically and will adjust speeds between low and high. Be
careful because the belt will change speeds without warning. When the
calibration is finished the display will return to the start-up screen.
