Bezzera BZ07 DE, Instruction Manual

Page: 28 / 60

28
MOD.
BEZZERA BZ07
Problem Diagnostics/Solution Advice
The coffee distributed is
too cold
Possible causes:
1 - The filter holders are cold.
2 - The coffee has been ground too finely.
3 - The machine's water circuit is dirty
(limescale).
4 - The boiler pressure is below 0.8 bar
(0.08 MPa).
In case 1, keep the filter
holder assembled on the
unit.
In case 2, alter the coffee
grinding.
In cases 3 - 4, call a
specialised technician.
The coffee distributed is
tepid. The coffee distributed is tepid, even if the
pressure is found to be normal, between
1 and 1.2 bar (0.1 - 0.12 MPa). In this
case, pressure monitoring is fictitious. Call a specialised technician
to check the airhole valve.
In the meantime, however,
in order to use the machine,
open the steam tap (Fig. 1 -
pos. 9), the boiler pressure
will go down to zero, and
this will cause the resistance
to step in and increase the
temperature. Carry out this
operation daily when turning
on the machine.
The coffee distributed is
too hot
Possible causes:
1- The boiler pressure is more than 1.3
bar (0.13 MPa).
2- The machine is covered by something
that prevents it from cooling down.
3- The machine has been installed in a
position that does not allow air to
circulate.
In case 1, call a specialised
technician.
In cases 2-3, restore
the machine's cooling
conditions.
Coffee deposits on the
bottom of the cup
Possible causes:
1- Coffee is ground too finely.
2- The filter holder is dirty on the inside or
the filter is damaged.
3- The coffee mill's grinders are worn.
Case 1 can be solved by
correctly adjusting the coffee
mill.
In case 2, clean the filter
holder or replace the filter.
In case 3, a technician must
be called.
Downloaded from CoffeeMachineManual.com Manuals