4
CHARGING THE BATTERY
1. Plug the power supply into the charger base. The socket is located at the back of the charger base.
2. Plug the power supply into an electrical outlet.
3. Place curing unit with battery into the charger as shown in Figure 1 or 2.
Please note:
The charging status lights are located on the top of the charger base and indicate the state of battery charge.
•
Yellow light
—battery is charging
•
Green light
—battery is fully charged
BATTERY DISPOSAL
: The battery pack contains a Lithium ion (Li-ion)
battery. Recycle or dispose of batteries according to national, state and
local regulations.
ACTIVATING AND DEACTIVATING THE LIGHT
• Press the button “1”; the light will turn on.
• If desired, the light can be turned off by pressing
the ON/OFF button before the exposure time is over.
CURING LIGHT CHARGE BASE
Included with the Slimax-C Plus is a built in radiometer.( See Fig
-
ure 2) It is located on the Charge base for easy access to measure
the instant output of your curing light. To use the radiometer,
please ensure that the charging base is plugged into a power outlet.
Turn the curing light on and activate the light. Then insert the
light guide into A (Seen in Figure 2). The measurement reading
will be shown on the display screen.
Figure 1
MODE
Your New Slimax Curing System offers three different operational modes:
F (Full):
Provides Maximum Power
R (Ramp):
The output gradually reaches Maximum Power
P (Pulse):
The Power Pulses ON and OFF
Select Modes:
Press button “2” continuously for three seconds
EXPOSURE TIME
F (Full):
5,10 seconds
R (Ramp):
10 and 20 seconds
P (Pulse):
10, 20 and 30 seconds
Select Exposure Time
: Press Button “2”
On/Off Button
Time & Mode
Change Button
Display Panel
Mode Indicator
Figure 2
A
display screen