2
Operation Manual
•
Equipment Classification
- Class II equipment:
- Type B shock protection:
- Recommended sterilization: See 7. Sterilization
- Do not use in the presence of flammable liquids or gases.
Cautions for safe handling and operation
Read these safety precautions first before using this product.
These instructions will show you how to operate this product safely and prevent injury to yourself
or others. They are classified by the degree and/or severity of danger. All cautions regarding safety
should be observed.
Classification
Degree and severity of danger
Warning
Provides an instruction where personal injury may occur.
Caution
Provides an instruction where minor to medium injury may occur.
Notice
Provides an instruction that should be observed for safety reasons.
Warning
- To Prevent Electric Shock: Do not plug in the power cord with wet hands.
- To Prevent Electric Shock: Prevent water from getting on to the control box.
- To Prevent Electric Shock: Plug in and remove the power by holding on to the base of the plug and
not the cord.
- To Prevent Electric Shock: Use an electrical outlet which is grounded.
- If you feel any abnormality such as excessive vibration, heat, or noise, stop using the unit
immediately.
Caution
- When operating this system, always consider the safety of the patient.
- The product is designed for clinical dental use by qualified personnel
- Every connection must be firm. If it is not firmly connected, it may cause an air or water leak, or the
LED might not turn on.
- Do not drop the product or cause it to be impacted in any way. This could cause a malfunction and
damage.
- This system is to be used with ISO 9168, type B or type C hose connector.
- This system is meant to function in temperatures of 0-40°C (32-104°F), humidity at 10-85% RH,
atmospheric pressure 700-1060hPa and no moisture or condensation in the Control Unit. Operating
outside of these parameters can cause a malfunction.
- When installing the Control Box or Motor, do not bend or twist the tubing or the cord. No excessive
force is need to do the installation.
- Do not use contaminated air (by dust or moisture). If the air contains water or dust , it might cause
a malfunction or overheating.