TG 500 – Beltpack transmitter
25
• To switch off the transmitter, press and hold the on/off button
until the “Off” message is displayed.
• If the “Tx lock” function is activated, it is still possible to switch
off the transmitter. Press the on/off button
until the message
“PW Lock” appears on the display
. Release the on/off button
briefly and then press it once again until the “Off” message is
displayed. The transmitter is then switched off.
• If the “Mute” function on the receiver is activated, you can
mute the microphone by briefly pressing the on/off button
.
The activated mute function is indicated by the “M” symbol on
the display. The microphone mute function is indicated both on
the receiver display (“TX mute”) and on the transmitter display
by the word “Mute” and the name entered on the receiver
alternating on the display.
• If you wish to switch to “RF off” mode, hold down the on/off
button
on the transmitter until the message “RF off” appears
on the display. You can now synchronise a spare transmitter to
the same channel, for example, even though the main
transmitter is still active (audio continues to function while
synchronising).
• Perform synchronisation for the spare transmitter.
• To leave “RF off” mode, turn the transmitter off and on again.
off
Figure 4-17:
Switching off transmitter
pwlock
RF off
Figure 4-18:
Power lock message
Figure 4-20:
Mute function active
Figure 4-22:
RF off mode active
off
Figure 4-19:
Switching off in spite of power lock
user
Figure 4-21:
Microphone muted
mute
4.4
Using the sensitivity switch
• The input sensitivity can be set in three stages (0 dB / +12 dB /
+24 dB).
• In addition, the output level of the receiver can be adjusted in
the receiver menu. See chapter 2.8 “Menu settings”, section
“Gain”.
Figure 4-23:
Connecting the microphone
Figure 4-24:
Adjusting sensitivity
4.5
Fastening the belt clip
• There are two belt clips for the beltpack transmitter that you
can use to attach the beltpack transmitter to clothing, a belt, a
guitar strap etc. The beltpack transmitter is supplied with a belt
clip for upright attachment. A belt clip for sideways attachment
is optionally available.
• You can remove the belt clip by pulling it out sideways from its
attachment on the beltpack transmitter.
• The belt clips can be attached upright or sideways
Upright:
to attach the transmitter to clothing or a belt,
for example
Sideways:
to attach the transmitter to a guitar strap,
for example
Figure 4-25:
Belt clip upright
Figure 4-26:
Belt clip sideways
