Synexis – Synexis TH2 Handheld Transmitter
10
3.2
How to insert/replace the batteries
•
Slide down the lid
to open the battery compartment
.
•
Insert the supplied NiMH rechargeable batteries according to the polarity marks.
Before
using the transmitter for the
first time
, the rechargeable batteries inside
must be charged e.g. with the Synexis C8 charger. As an alternative you can use
two 1.5 V AA alkaline batteries.
•
Close the battery compartment
by sliding the lid
to the top.
H
L
3.5
How to turn the transmitter on/off
•
Turn on the handheld transmitter by pressing the on/off button
for approx.
3 seconds.
•
The battery status, selected channel and mute function are displayed
.
•
After use turn off the handheld transmitter by pressing the on/off button
for
approx. 3 seconds.
3.4
How to set the gain
•
Inside the battery compartment
you will find the gain switch
to set the
gain for close or distant miking. Remove the batteries first and then set the gain.
Position “High” = set switch to “H”
Position “Low” = set switch to “L”
3.3
Battery status display
•
The battery status is displayed
in 4 stages.
•
If only one bar is displayed, you should recharge the receiver as soon as possible.
•
If the battery frame is flashing, the batteries are empty and have to be replaced or
recharged.
•
If the transmitter is equipped with rechargeable NiMH batteries, put it into the
appropriate charger (e.g. Synexis C8). Despite the Auto-Off function we
recommend turning off the transmitter before charging.
Depending on the charger, the LED of the charger or the LED
indicates the
charging status:
LED is flashing blue . . . . . . . . . . The batteries are being charged
LED illuminates blue. . . . . . . . . . The batteries are fully charged
LED is flashing red . . . . . . . . . . . Error
