english
35
3. Connect the NE 800 receivers to the ZAS 800 antenna splitter with the supplied cables.
4. Connect the power supply unit to the DC-connection (3) and to AC power. (Attention:
Make sure that the indicated voltage corresponds to the local voltage.)
5. Switch on the ZAS 800 antenna splitter (1).
1.7.3 General Information
1. The antenna sockets (4) have a voltage of 8 V DC. To avoid a short circuit the sockets must
not touch the rack housing.
2. For the connection of remote antennae use usual 50
Ω
coaxial cables. The longer the cable,
the higher the RF signal loss. Therefore, the cable length should not exceed 6 m.
The larger the diameter of cable, the lower the signal loss. If you need cables longer than
6 m you should therefore use cables with a larger diameter to reduce the loss of signal.
3. Use 50
Ω
coaxial cables to connect the NE 800 receivers to the ZAS 800 antenna splitter. The
distance between these devices should be as short as possible. We recommend you to use
the supplied cables.
4. Supplied Accessories:
8 x RG 58 AU cables, 40 cm (TNC)
1 pair rack mount brackets
1 x 12 V / 500 mA power supply unit
