Chapter 4. Door Station Installation
IP Video Door Station DS06M(P) Installation User Manual
15
The patch cable must have the RJ45-S01 connector at the end connected to the door station! It is
impossible to connect the door station using a cable connector of some other form.
The twisted pair cable (5
е UTP/FTP) connected the door station with its controller should
be wired the same at both ends (
“straight-through” form).
ATTENTION!
The device breakdown caused by wiring the cable in different manner is not covered by the warranty.
Use the cable of the minimal possible length to connect the door station and its controller. Proper
operation of the device cannot be guaranteed in case of using of the 10 m cable and more.
Step 7
: connect the crimped cable to the door station, sealing the connection area, and put
it in the bracket frame. Rotate the door station in the frame to set the appropriate view direction of
the built-in IP camera. Place a excess part of the cable as it is shown on the picture below:
Pic. 4.5
Step 8
: specific notches of the bracket frame and the door station (
Pic. 4.6)
allow the
station to be fixed well and prevent loose rotation during operation.