Chapter 3. Overview
IP Video Door Station DS06M(P) Installation User Manual
9
1
–RJ45 socket (“ETHERNET”/“DOOR ST”)
is used for connecting the NC103 / NC103P
/ NC311P controller to the door station via a patch cable. The patch cable should be made using
RJ45-S01 connectors from the package contents (see paragraph
ATTENTION!
The patch cable must be connected to the door station via an RJ45 connector! It is impossible to connect
the door station using any other cable connector .
2
– terminal connector (ALARM OUT)
: is used for connecting a door lock or another
device controller. In case of connection to the 1-channel door station controller, NC103 or NC103P
(shown on the
Picture 3.5
), the signal opening the door outputs to the lock controller is transmitted
via
«1A» and «1B» pins.
In case of the 3-channel NC311P controller , the signal opening the door outputs to the lock
controller is transmitted via
«1A» and «1B»/«1С», «2A» and «2B»/«2С», «3A» and «3B»/«3С»
pins for the first, the second and the third channel accordingly (
Pic. 3.6
). The
«A» and «B» pins are
normally open, and the
«A» and «С» pins are normally closed.
The
«G» and «12V» pins of the NC103 controller (without PoE support) are used for DC
12V power supplying of the door station. It is necessary to connect a power supply recommended
by BEWARD and the lock controller to these pins.
The
«G» and «12V» pins of the NC103P / NC311P controller (with PoE support) are used
for powering the lock controller (several lock controllers) with DC 12V. In this case it is necessary
to connect only the lock controller to these pins.
ATTENTION!
Use only DC 12V power supplies recommended by BEWARD!
Power supplying using both PoE and t
he «G» and «12V» pins
(
for NC103P and NC311P controllers) at
one time is prohibited!
ATTENTION!
Maximum current rate provided by the NC103P, NC311P controllers for powering door locks and their
controllers is 500 mA. If this value is exceeded the device may malfunction or break. The device
breakdown caused by the exceeding of the maximum current rate is not covered by the warranty.