a. Connect Wirelessly: Turn on the WiFi with the slider at top right
of the screen. Select the appropriate network and enter the
password if necessary.
b. Connect via Ethernet: The ethernet port on the standup is
located beneath the power button on the back of the machine.
Simply plug the cable into the port and it should connect
automatically. In newer countertop models, the ethernet cable
hangs from the bottom of the head unit and will thread down
through the 4” hole in the countertop. And extension cable can
be used if it does not reach the ethernet jack.
c. Connect via OptConnect
TM
: After installing and initializing the
OptConnect
TM
, enter the Serial Number in the box and press
Done .
3. Return to the Service Panel main page and check that the internet is
properly connected. The icon on the left of the network field should be
green, with a “Connected” tag and the connection type listed.
Initial Stocking
Flavors
For each flavor, perform the following steps to initialize:
1. Press the Restock button to bring up the flavor list.
2. Type in the two digit ID number found on the flavor box, and select the
appropriate flavor for the new concentrate.
Note: Make sure to go by the number on the box, not just the flavor
name. Differently numbered flavors can have differing concentration
dispense ratios.
3. Place a bucket or large container under the nozzle and prime the line
for at least 15 seconds, or until concentrate freely flows. You can press
and hold the Prime button, or double tap it to let it auto pour. Tap it
again to stop the flow.
CO
2
To initialize the CO
2
, press Restock and select 5lb or 10lb (we recommend 10lb
tanks).
© 2018 Bevi. All rights reserved. [email protected]