
Never insert the sound tube into the ear canal without an earplug. Make sure also not to press the tube
and earplug too deeply into the ear canal.
Switching on/off
In order to switch the hearing amplifiers
on/off, hold down the program
selection button on the device for three (3)
seconds until you hear a beep.
Adjusting the volume
Plus button:
Increases the volume (press briefly)
Minus button:
Use the volume button to adjust the volume to the desired level so that you can hear sounds clearly and
distinctly.
Note
:
•
If you hear a slight whistling sound when wearing the hearing amplifier, check that your earplug is
fitted properly in your ear. If it is not snug enough, use a different earplug.
•
The hearing amplifier does not heal an existing hearing impairment, but it does improve hearing and
speech understanding.
•
If you hear a single beep, the volume has been increased or reduced.
•
If two beeps sound in succession, the highest or lowest possible volume has been reached.
Setting the hearing programmes
To change the hearing program, press the
program selection button.
P1: Normal mode (1x beep)
:
Suitable for quiet environments, e.g. at
home or in the office.
P2: Noise reduction mode (2x beep)
Suitable for outside areas, e.g. on the move, in the
supermarket :
Beep
/
Beep Beep
♪♪
or restaurant.
Changing the battery
To change the battery of the hearing amplifier,
hold the battery firmly with one
hand, and with the other hand push the upper
part of the hearing amplifier in
the opposite direction. Now take the fully
charged spare battery and slide it
onto the hearing amplifier. The hearing amplifier
is now ready to use again.
Inserting the drying capsule
Beep
♪
Decreases the volume (press
briefly)
Beep
♪
♪