16
Use of the thermometer
1. Keep the SCAN-button (fully pressed
down for one second) (special design to
avoid accidental contact). The system
begins with a self-test after 1 second; see
Figure 1. When switching on, never press
the SCAN button for more than 5 seconds,
as otherwise you will get a
special measurement mode in which the
device will not make a correct measure-
ment. Let the device switch off automati-
cally and then switch it on again correctly.
2. As soon as the self-test is complete, will
appear the last measured temperature
on the display (Figure 2). This is a sign
that the thermometer is ready to make a
measurement.
3. Place the measuring head on the temple,
keep the SCAN-button held down and
then pull evenly across the forehead to
the other temple (Figure 3).
Figure 1
4. Let go of the SCAN-button and read the
measured value. At the end of the measu-
rement an audible signal will sound. The
measured temperature appears on the display
together with a face symbol (see Figure 4).
Figure 4
Figure 3
Figure 2
Applicable Standards
This product conforms to the requirements of the EU Guidelines
MDD(93/42/EEC). The following standards are valid for the
construction and/or manufacture of the product:
ASTM E 1965-98
- Standard specification for infra-red
thermometers for the intermittent measurement of body
temperature of patients.
EN 980:1997
–-Graphic symbols for labelling medicinal products.
EN 60601-1
–-Medicinal electrical devices – Part 1: General
stipulations for safety
EN 60601-1-2
–-Medicinal electrical devices – Part 2:
Supplementary standard: Electro-magnetic compatibility
– Requirements and testing
