28
Selecting memory
Press the
SET
setting button. Select the relevant user memory
( or
2
) by pressing the
-
/
+
function buttons.
You have 2 memories, each with 100 memory spaces, to
enable the separate storage of measurements for 2 different
people. Confirm your selection with the
START/STOP
button
or wait for 3 seconds. Your selection is then automatically
stored.
Performing the blood pressure measurement
Measur
ement
As described above, attach the cuff and adopt the
posture in which you want to perform the measurement.
• Press the
START/STOP
button to start
the blood pressure monitor. All display
values light up briefly. After the full-screen
display, the last stored measurement ap-
pears. If there is no measurement in the
memory, the unit displays the value .
The blood pressure monitor will begin
measurement automatically after 5 seconds.
Measur
ement
The cuff automatically inflates. The measurement itself is
taken during the inflation phase.
As soon as a pulse is found, the pulse symbol will be
displayed.
You can cancel the measurement at any time by
pressing the
START/STOP
button .
• Systolic pressure, diastolic pressure and
pulse measurements are displayed.
•
appears if the measurement has
not been performed properly. Refer to
chapter “10. What if there are problems?”
in these instructions for use and repeat the
measurement.
• Press the START/STOP button to switch off the
blood pressure monitor. The measurement is then
stored in the selected user memory.
If you forget to turn off the device, it will switch off
automatically after approx. 1 minute. Even in this event,
the value is stored in the selected or most recently used
user memory.
• Wait at least 1 minute before taking
another measurement!
