10
BetterOutdoorProducts.com
Initial Setup
Uncrating
1. Open container and remove all packing material.
2. Using a 9/16 wrench, remove the four handlebar
mounting bolts
Figure 2
.
Figure 2
3. Rotate the handlebar assembly 180 degrees
and reinstall handlebar mounting bolts in one of
the two positions.
Note:
Mounting handlebar in the top holes
raises grips approximately 1”.
4. Cut banding straps that hold machine to pallet.
5. Locate ground cables, remove tape and attach
both wires to rear engine mounting bolt (electric
start machines only)
Figure 3
.
Figure 3
6. Using the 5/16 keps nut located in your Owner’s
Manual bag, secure ground cables to rear
engine mounting bolt using a ½ wrench.
7. Place transaxle lever in Easy Roll Around
position
Figure 4
.
Figure 4
8. Depress the red operator presence/parking
brake lever and remove machine from pallet
Figure 5
.
Figure 5