28
Assembly Instructions for Table-top Stand
Tools required (not provided): Phillips screwdriver, stud finder, power drill and 3 mm/0.1 in drill bit.
29. Position the assembled stand at the desired location against a wall. If necessary, adjust the
pre-attached Floor Levelers at the bottom of Legs (R and S) to level the unit. Now, follow the
instructions printed on the plastic bag containing the Tipping Restraint Hardware to attach the
tip-over restraint to the Back Frame and the wall.
NOTE: The tipping restraint hardware included is for wooden stud wall construction. It must be
attached to a wall stud. Depending upon your wall construction, different anchor hardware maybe
required. Please contact your local hardware store for assistance. Young children can be seriously
injured by tipping furniture. You must install the Tipping Restraint Hardware with the unit to
prevent the unit from tipping, causing any accidents or damage. The tipping restraints are intended
only as a deterrent, they are not a substitute for proper adult supervision. The tipping restraints are
not earthquake restraints. If you wish to add the extra security of earthquake restraints, they must be
purchased and installed separately.
30. The stand is now ready for use. Be sure to position your Flat Panel TV in the center of the
stand.
NOTE
: If you choose the Tilting Wall Mount, proceed to PAGE 37.
TV
R
S
