10
11
x 1 9
STEP 6
1. Make sure the screws go through pre-drilled holes properly.
2. Do not over tighten screws.
4 . 1 5 m m P a n
H e a d S c r e w
hole for anti-tip strap
NOT TO SCALE. REFER TO PAGE 3 FOR ACTUAL SIZE HARDWARE.
Begin by installing all of the screws along one
edge of the back panel. Next, using a square
or tape measure, make sure that the case is
square. (if using a tape measure, the distance
from one corner, diagonally to the other corner
should be the same in both directions.) Install
the remaining screws, starting with the corners.