Page 3
Step 4:
Fig.5
Hand tighten only.
Step 5:
Do not over tighten bolts. If nuts and bolts are too tight or too loose,
the glider will not function properly.
Step 6:
by using four 5/16"x3 mm bolts and four
washers as shown in
. Guide the
bolts through holes in base, into the pre-drilled holes in the seat.
Using the hex wrench and hex bolt driver provided, tighten all nuts and bolts.
Test the operation of glider. Gliding motion should be smooth. Adjust the tension on the glider brackets, nuts
and bolts as needed. Cover nuts and bolts with covers provided.
With the help of another person, turn the glider in the upright position. Your glider is now ready for use. If you have any questions, please call our
Customer Service Center at 1-800-416-3511.
Ø8 5 X 1.5mm
.
Attach the completed base to the completed seat frame
5
IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or improper assembly is not covered under our warranty. Please
read all instructions carefully before assembly. If you have any questions regarding your assembly, call our Customer Service Center at 1-800-416-3511.
Fig.5
C
G
