Page 2
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
Step 1:
Do not attempt to assemble glider if any parts are missing or damaged.
Step 2:
Carefully unpack and identify all parts packed in the carton against the parts list. Remove all protective materials. If you are missing any parts or unsure how to
proceed with assembly, please call our Customer Service Center at 1-800-416-3511.
Assemble furniture on a smooth, non-abrasive surface.
as shown in
. Guide one 1/4"x30 mm bolt and
washer through the hole in the back frame,
into the pre-drilled hole in the
. Guide one 1/4"x30 mm bolt and
washer through the hole in the right arm, into the pre-drilled
hole in the back frame.
by using two 1/4"x30 mm bolts and two
washers as shown in
. Attach the seat frame to the back frame by using two 1/4"x20 mm bolts, one 1/4"x40 mm bolt, and three
ashers as shown in
.
Repeat above process (Fig.1 & Fig.2a) for the opposite side as shown in
.
Fig. 1
Hand tighten 2-3 turns only.
Fig. 2a
Fig.2a & Fig.2b Hand tighten 2-3 turns only.
Fig.3
Ø6 5 X 1.0mm
Ø6 5 X 1.0mm
Ø6 5 X 1.0mm
Ø6 5 X 1.0mm
w
.
.
.
.
Attach the back frame to the right arm
right arm
Attach the seat frame to the right arm
Attach the support frame assembly to one side of the glider base brackets. Use the two 1/4 x 45 mm bolts with Ø6.5x1.0mm washers as shown in
:
insert the bolt with washer through the hole in the
/Ø15x6mm
washers/
/Ø6.5x1.0mm washers/nuts. Hand tighten only
as some adjustments may be necessary for proper alignment or tension of the glider. Repeat on the opposite side.
Step 3:
Fig.4
glider bracket
support frame
plastic
M
O
P
N
R
Q
B
F
B
F
J
I
H
F
E
Fig.1
Fig.2a
Fig.3
Fig.4
F
B
A
F
FOOT CAP
A
F
D
F
Fig.2b
F
