3
SAFETY
•
This cabinet should be installed by a qualified electrician.
•
This fitting is only suitable for connection to a 220-240V earthed supply in accordance
with current IEE wiring regulations, and should be installed in accordance with local
Building Regulations.
•
This is for domestic, indoor use only.
•
The cabinet should be connected to a dedicated lighting circuit which must be
protected by a 5-amp fuse (or a 6 amp miniature circuit breaker).
•
The electrical connection must be an adequate distance from the rear of the cabinet
to prevent the risk of shorting with the cabinet
’s casing.
•
Before installing the fitting ensure that the mains supply is switched off, and that the
appropriate fuse is removed (or appropriate circuit breaker is switched off) before
commencing installation. Ensure that measures are taken to prevent the supply from
being inadvertently reconnected.
•
If there is a “Minimum Distance” label, please do not allow flammable materials to
rest within that distance from the unit.
•
This product may contain delicate parts
–
be careful during handling and
maintenance to avoid breakage.
•
Ensure the cover for the shaver socket is closed when not in use to prevent moisture
from entering it.
•
Only connect items designed to be used with a shaver socket (Such as shavers or
electric toothbrushes).
•
The shaver socket is not earthed and provides 230V at a maximum current of 80mA.
Do not connect devices which require a higher current, different voltage, or an earth
connection.
•
If any modification is made to the fitting it will invalidate the warranty and may
render the product unsafe.
•
A defective appliance may cause electric shock. Never switch on a defective or
damaged appliance. Disconnect the appliance from the mains before seeking
assistance.
•
This product is IP44 rated, and no part of the installation is allowed to be within
bathroom Zones 0 or 1. Installation is permitted within Zone 2.
•
This product must be earthed. Before commencing installation, ensure that there are
no pipes or wires located behind the wall that may be damaged during drilling.
•
Ensure that the hanging location has been decided upon and marked clearly to avoid
unwanted damage to the wall due to incorrect positioning.
•
Inspect the cabinet to ensure there are no signs of damage prior to installation.
•
Take care unpacking, do not use a sharp blade to open as this may damage the
product and void your warranty.
•
Once installed a bead of silicon can be applied between the cabinet and the wall
across the top and sides of the unit. Never seal the bottom of the cabinet to the wall,
as this may allow water to accumulate behind the unit.