Target: Terror
.
Copyright 2005
.
Raw Thrills Inc
.
All rights reserved.
SECTION 2: INSTALLATION AND INSPECTION
WARNING: Use extreme care when moving or servicing the game cabinet. Don’t plug in the
game until you have read this manual.
Please check the following after the game after the game has been removed from its shipping
crate and placed in a suitable play or service area.
1. Make sure that the game cabinet is level. Adjust the casters as needed. This should be
done by two individuals.
2. Check the AC line cord for any visible signs of damage to the plug or line cord
insulation.
3. Check for possible shipping damage to the following:
·
Gun assembly: left/right guns, holsters, and cable.
·
Cabinet glass: marquee and monitor.
·
Cabinet backdoor.
·
Cabinet coin door.
·
Cabinet decals.
4. Remove the coin door key from the coin return chute.
5. Open the top coin door and locate the key for the backdoor and the cashbox.(Skip to
Step 11 for 27 inch Models).
6. Locate hardware kit.
7. Remove (3) wood screws from top cover of monitor cabinet mating block to gain access
to wire connections for gun cabinet.
8. Make necessary electrical connections (4 connectors).
9. Use ¾ inch(20mm) hex bolts from hardware kit to secure monitor cabinet to gun
cabinet.
10. Replace top cover to monitor cabinet mating block.
11. Plug the game line cord into an AC receptacle.
12. Locate the game AC main switch to the bottom left side on back of the game cabinet.
13. Turn the switch to the ON position.
14. The game attract feature will begin after the game is finished loading- approximately 1
minute.
15. Proceed to Section 3 of this document for game setup and verify proper operation.
