July 28, 2004
The Fast and the Furious Drift • Copyright 2007 • Raw Thrills Inc • All rights reserved
.
7
Seat Assembly Procedure
WARNING: The cabinet is top heavy. Install only on level surface. Use the leg levelers to make sure the cabinet
and seat are stable. Do not push against plastic parts during movement.
1. Roll the cabinet and seat to the intended location and lower the leg levelers until both are equal height
and stable.
2. Reach inside the base of the cabinet remove the bolts to fasten a mounting rail to the cabinet and set
aside. Individually pull the rail out, flip it end over end and reinsert it. Fasten the rail to the inside of the
cabinet with bolts until finger tight; some movement is required in the mounting rails to align holes with
seat pedestal assembly. Repeat for the mounting rail on the other side. See diagram.
3. Roll the pedestal near the cabinet and align the opening in the pedestal with the ends of the rails. Slide
the pedestal forward onto the rails leaving enough space to attach the wiring harness. Mate each cable
connector and press firmly to seat the contacts. Ensure no wires are pinched during the pedestal
attachment. Fasten in place with the ¼” X 20 tamper resistant screws and large flat washers provided.
4. Tighten the screws firmly with the wrench provided, and then tighten the bolts for the mounting rails.
5. Adjust all levelers until both cabinet and seat are flush and parallel with each other. Inspect for pinched
wires before firmly tightening the remaining fasteners to attach the two pieces as one.
Power Up Procedure
1. Plug the game line cord into an appropriately wired and fused AC receptacle.
2. Locate the game AC main switch to the bottom left side on back of the game cabinet.
3. Turn the switch to the ON position.
4. The game attract feature will begin after the game is finished loading- approximately 1 minute.
5. Proceed to Switch Test of this document and verify proper game operation.
