Beton Trowel nv
Nijverheidsstraat 11
1840 Londerzeel/Belgium
Tel: +32 (0)52 315 350 - Tel: +32 (0)52 315 351
Fax: +32 (0)52 303 739
E-mail: [email protected]
BE 0821.249.312
www.betontrowel.com
BNP FORTIS:
ING:
BE81 0015 9813 5624
BE
- GEBABEBB
BBRUBEBB
Pag.
16/35
BELT TENSIONING SPECIFICATIONS
NOTE: Belts may become slightly loose after the first few hours of
operation. It is important to retension the belts with the tool provided
and use the table given as reference.
2
Lubrication
ENGINE OIL
The long life and successful operation of any piece of machinery is dependent on
frequent and thorough lubrication.
Before using the trowel, always check your engine for oil. Use proper engine oil as
recommended in the engine manufacturer’s manual. Fill crankcase to levels as
recommended.
SPIDER PLATE
There are 8 (eight) grease fittings on the spider plates, 4 (four) on each must be
greased daily.
SPIDER PLATES MUST BE GREASED EVERY TIME MACHINE IS USED.
GEARBOX
Check the oil level sight plugs on both gearboxes daily to ensure the oil is half way
on the site glass. Top up with Agma 8 compounded gear oil only. Gearbox capacity
on the BT900 is 27oz./767ml.
TO CHANGE GEARBOX OIL
Place a pan beneath the drain plug to catch the oil. Remove the drain plug and the
filler plug from the gearbox. After the oil has drained completely, replace the drain
plug and tighten. Fill the gearbox through the filler plug with 27oz./767ml. of Agma 8
compounded gear oil. Replace the filler plug and tighten.
GREASE FITTINGS
There are 6 bearings in total. Grease all bearings and U-joints to ensure adequate
supply of lubricant. They are located above the gearboxes (2 per gearbox) and
2 located in the drive system. The U-joints are located in the drive system as well.
