11.0 CONTROLS AND FUNCTIONAL PARTS
11.1 CONTROLS (FIG. 5)
1.
Main switch
Start/Stop switch for the current input.
2.
Mains light
Light that comes on when the plug is connected to the socket.
3.
Handle release
Operates the releasing of the handle articulation
(give half a turn counter-clockwise).
4.
Fuse
Protects the electrical equipment.
5.
Brush switch
On/Off switch for operating the motor of the brush.
6.
Suction switch
On/Off switch for the suction motor.
7.
Water pump switch
On/Off switch for the pump.
8.
Water pump button
Button: as above (to operate the pump non-stop).
11.2 HANDLE
The handle (2 FIG. 3) of your machine can assume four different positions.
To release, turn the lever (3 FIG. 3) counter-clockwise as far as it will go; this operation releases the two articulated
joints simultaneously. The handle can adopt the following positions (FIG.4):
T=Transport
In this position the machine is less bulky and can be lifted by gripping the handle in the
midline (A).
R=Rest
A special spring lifting device (18 FIG. 2) lifts the brush from the floor and therefore reduces
the pressure exerted on the rubber .pads of the squeegee, in order to avoid damage. In this
position, the machine can be moved from room to room and stored.
L=Work
In this position the lifting device is disconnected and the machine is ready for use.
LB=Low work
To facilitate cleaning under tables, benches, furniture, etc., the handle can be released from
its Work position and bent as far as desired.
The machine must be put away with the handle in T or R position after use.
11.3 FLOOR WIPER (SQUEEGEE)
Squeegees are devices that enable drying of the damp floor. If the machine is not drying effectively, check for any
dirt or foreign matters on the squeegee. In this case, you will have to remove the squeegee to clean it.
11.3.1 DISASSEMBLY
1)
Set the handle in R position (FIG. 4).
2)
Remove the side lock of the squeegee support
by pulling it upwards.
3)
Remove the floor wiper
by pulling it out as if it were a drawer
from the opposite side of the locking.
ATTENTION:
The lock on the rear squeegee
is
on the right
of the machine, while that of the
front squeegee
is
on
the left.
6
Fig. 5
NOTE
