INSTRUCTIONS
BEFORE STARTING THE MACHINE
Before any operation should begin, you first should read your Engine Operation
Manual and your Owner’s Manual.
Your machine is shipped ready for your operation, however there is no fuel in the
tank. When having the tank filled, you must make sure the tank is never over
filled.
The best way to do this is to tell the filling station to weigh the tank full. On an
aluminum tank, it should weigh no more than 36 pounds and on a steel tank no
more than 43 pounds.
Adjustable Handle: Adjust the handle for comfortable operation. Use two 3/4”
wrenches and loosen handle. Adjust to comfortable height and re-tighten bolts to
40-50 ft/lbs.
•
Check Oil Level: Starting the engine without the proper amount of oil will
cause severe engine damage. Always keep the engine oil level between the
full and add marks on the dipstick. Do not loosen oil fill cap or remove dipstick
while engine is running.
o
Park your PB 17-V-Twin on a level surface.
o
Turn the oil fill cap counter clockwise and then lift from the fill tube.
o
Wipe the dip stick clean and push it back into the oil fill tube until the cap
seats and then withdraw it to check: the oil level. (Do not screw cap on to
check oil). Add if necessary. If the oil level is low, add API Class SG or SH
oil having a SAE viscosity grade appropriate for the expected
temperatures as indicated in the Operators Manual.
o
Important Note: DO NOT OVERFILL
o
Replace oil cap.
•
Inspect fuel hoses and fittings for leaks. Repair leaks immediately.
•
Look and listen for exhaust leaks. Have all leaks repaired before operating.
•
Check the carburetor filter and air filter for debris. Clean and replace if
necessary.
•
Connect fuel hose to tank by screwing the hose fitting to tank. You must
tighten all the way down to make fuel connection. Turn tank knob slowly until
you hear the flow of fuel into fuel system.
- 9 -
Summary of Contents for Big Bertha
Page 2: ...2...
