INSTRUCTIONS
STARTING THE ENGINE
The PB 17-V-Twin is equipped with a 12 volt starter and a key switch
start.
(1) Start the Extreme Strip machine with the brushes in the running
position, flat on the floor.
(2) Open propane tank valve (turn counterclockwise).
(3) Put throttle cable into the “slow” position.
Note: If starting is difficult, you can place throttle in the “fast”
position, and after the engine starts, back off to the slow
position before the centrifugal clutch engages.
(4) Turn the ignition - start switch to the “start” position and hold it
there until the engine starts. Do not crank for more than 20
seconds at a time and wait at least one minute between tries
when cranking. See troubleshooting guide if the engine does not
start after several tries.
(5) After engine starts, set throttle so that the centrifugal clutch will
not engage until the engine has warmed up. Do not operate
machine until the engine has warmed up sufficiently. ( 3 to 5
minutes )
STOPPING THE ENGINE * * *
1. Turn propane tank valve to the closed position (turn clockwise)
and allow the engine to continue running until it runs out of fuel.
This can be done with the centrifugal engaged or not engaged.
* * *
2. Turn key to the off position.
* * *
In an emergency, immediately turn
the key to the off position.
Backfiring may occur when using this method.
-10 -
Summary of Contents for Big Bertha
Page 2: ...2...
