Betamotor EVO 4t, Workshop Manual, Page: 60 / 80

54
ASSEMBLY
betamotor.com
After you have fitted all the friction plates, fit the
pressure plate lifter (10) in the central hole in the
clutch basket, together with the lifter needle roller
bearing (11) and the corresponding washer (12).
Check the wear on the needle roller bearing and
the contact surfaces. Replace the components if
they show excess wear.
Check the length of the springs (14):
Minimum value 33.3mm (33.8mm when new).
Fit the clutch pressure plate (13), the clutch springs
(14), the special washers (15) and the M6x16 bolts
(16). Tighten the bolts (16) in diagonal sequence to
10 Nm. Tighten the TDC locking bolt once more.