12/2
0
4. It is important to have some rigid ladders to allow labourers to work up to
2,5 meter high .
5. Never walk over the welded mesh when spread over the ground, except to
join two rolls. Otherwise, each step damages/deforms the fence and will
influence the look afterwards. Of course, this can be adjusted by means of
the crimp tong but takes supplementary time afterwards. If there are
undulations in the fence after fixing properly, they can be removed by means
of the same crimp tong.
Crimp tong
Tension fork
6. When interrupting erecting fence ( for instance after a shift/before a
weekend), always fix the last end of the welded mesh on the “last
intermediate tension unit” with clips 10 to 15cm spacing between.
7. Prepare the fence line as straight levelled as possible and remove all dirt
(rock blocs, wooden planks,….) over a width of about 3 meter in front of the
posts: this decreases damages on the welded mesh and increases safety on
the job, the speed and the end look of the fence.
8.
In case of concrete on the lower part of the Bekaclip posts, clean them before
everything is hardened, otherwise it will be difficult or impossible to install
the
clips properly.
9.
If axe holes of the Fortinet
Protect
rolls are damaged during uncharging the
containers, cut away two or tree meshes. Keep in mind that, when fixing two
rolls together, it is important that the join is as flat as possible .
10.
If intermediate posts are not perfectly levelled, it is possible to adjust before
fixing the mesh by means of the black small tension forks by pushing the
posts to the left or to the right: this will upgrade the look afterwards .
Installation Guide Fortinet
Protect
–
December 2019
