3
CHECKS AND MAINTENANCE
35
USA
CHANGING THE GEAR AND
CLUTCH OIL
Before performing this operation, remove
the lower bumper
A
after unscrewing the
three screws
B
as shown in the picture.
The oil must be changed when the engine
is at operating temperature.
Park the motorcycle on level ground,
remove the screw
C
and let oil drain in
a container.
Thoroughly clean the screw and sealing
surface, put in screw
C
with the seal ring
and tighten at 20 Nm.
Remove screw fastner from right carter and
pour in gear oil PANOLIN OFF ROAD 4T
SYNTH 10W/40. To check the oil level,
unscrew the check bolt
D
. The oil level must
arrive to the lower edge of check hole.
Under conditions with high engine tem-
peratures and intense clutch use (deep
sand and mud) it is recommended to use
an increased clutch/gearbox oil quantity
of 1000 ml.
ATTENTION:
To check the gear oil level, it is necessary
to use the vehicle for fi ve minutes.
Tighten the check bolt.
ATTENTION:
Used oil contains hazardous to the en-
vironment. For the replacement must be
prepared for disposal in compliance with
the law.
C
D
A
B
B
