Beta 601C, Instructions For Use Manual, Page: 9 / 36

9
INSTRUCTIONS FOR USE
EN
7 [‰+ %*5*' 4 † X
to provide perfect stability (picture 2-o).
Šj>‹ X Jx† †
• When the set angle value is reached, the red LED will turn on.
• To store the value of the torque angle, press button M.
CAUTION: †X +†‰X [
been reached. To resume tightening, press button (S/S). To zero the device, press button C.
• To start a new tightening operation, press button S/S.
If the display is not used for approximately 2 minutes, it will automatically turn off.
SETTING UP MENU
Œ *5* 7 *5* ‡ &\#
TORQUE DIRECTION, TORQUE MEMORIES AND RESETTING TORQUE MEMORIES.
CHANGING TORQUE DIRECTION MENU
- The display will show PoS for the clockwise direction of rotation, and nEG for the anticlockwise direction
of rotation respectively.
"7
- To quit the menu, press button (S/S) several times.
TORQUE MEMORIES MENU
"4 [% => '
- If no values have been stored, the display will show nonE.
"Š X +†† [
- To delete one of the stored values, press button C twice.
- To quit the menu, press button (S/S) several times.
RESETTING TORQUE MEMORIES MENU
- This menu allows all the values stored in the TORQUE MEMORIES MENU to be deleted.
- The display will show ClrA
- To delete all the stored values, press button C.
- The display will show no?
- To delete all the stored values, press button C. To cancel the operation, press button S/S.
- To quit the menu, press button S/S twice.
ERROR MESSAGES
- Er4 indicates that the value has not been set correctly. Press button C to repeat the operation. Do not move the
angle indicator while setting.
"J= †‰ +7 KJ*J4
- Er--- indicates that the angle indicator was rotated too quickly during a measurement. Press button C to repeat the
operation.
"< +` +x =>
RESET
- If the angle indicator is not working correctly, press the RESET button to zero the device (picture 2-r). The angle
indicator can also be zeroed by removing the batteries.