Beta 601C, Instructions For Use Manual, Page: 8 / 36

8
INSTRUCTIONS FOR USE
EN
BATTERY INSTALLATION/REPLACEMENT
Install or replace the batteries as follows:
• Loosen the four screws of the battery compartment on the back (picture 2-l).
K X † X+ +%]### '
• Close the battery compartment, and tighten the four screws.
• Remove the batteries, if the digital angle indicator is not used for an extended period.
+ X ++†† +
DIGITAL ANGLE INDICATOR SAFETY
• Do not drop or hit the digital angle indicator.
• Do not use the digital angle indicator in humid or wet environments.
• To clean the digital angle indicator, use a dry cloth. Do not use alcohol or diluents.
x
• Do not modify the digital angle indicator. Changes may affect operation.
TECHNICAL DATA
MEASUREMENT RANGE 0° – 999.0°
ACCURACY ± 2%
RESOLUTION 0.1°
SCALE 1° to 360° (increment 0.1°)
PROGRAMMABLE ANGLE VALUES 9
STORED ANGLE VALUES 50
POWER SUPPLY 2 AAA batteries
OPERATING TEMPERATURE -10 °C ÷ 60 °C
STORAGE TEMPERATURE -20 °C ÷ 70 °C
HUMIDITY Max. 90%
AUTO POWER OFF After approximately 2 minutes
WEIGHT 95 g
KEY TO SYMBOLS
a: LED indicators
b: buzzer
d: digital display
c: start of measurement/menu button (C) m: memory button (M)
!
"
ON / CANC button (S/S) o: magnet
l: battery compartment
r: RESET button
DIGITAL ANGLE INDICATOR OPERATION
This device has been designed for right-hand/left-hand angle torque of screws and nuts in combination with impact wrenches,
ratchets or levers.
+ ? %&'4 [ †† +‡
- PoS (clockwise)
- nEG (anticlockwise)
When the symbol 0000 is shown on the display, wait a few seconds. After the required value has been set, the display will show
the previously set angle of torsion.
7 1X ˆ #† + 4
new value will automatically be saved in memory M.