22
ISTRUZIONI PER L’USO
I
OPERATION MANUAL AND INSTRUCTIONS
EN
STEP 6
Disconnect the fittings of the station, bringing the transmission line back to its original setting, and make sure
that there are no leaks. Move the gearshift to R D N P, to bleed the system. Start the car and move the gearshift
to either P or N; check the oil level.
- To fill up oil, IF NECESSARY, through the probe, press the key and place the probe on the PRESSURE pipe. The display
will show the following:
- Press to set the amount of oil to be filled up. Make sure that the probe has been placed on the PRESSURE pipe
correctly, and fit it into the oil level plug of the car; press the key.
- After the operation has been completed, the station will automatically enable the Printing of the entire process thus performed.
For smooth driving quality to be ensured, it might be necessary to drive 40-50 km.
DSG-AISIN TRANSMISSION
After connecting the “PRESSURE” and “RETURN” pipes, as described in the section “Use – Preparation for use”, take the
following steps:
STEP 1
- After connecting the “PRESSURE” and “RETURN” pipes, as described in the section “Analytical description of cycles –
Automatic transmission”, press the key; then press the key; the display will show the following:
- Press the key; the display will show the following:
- Press the key to set the required amount of solvent. If you are not going to feed any solvent into the car circuit, keep the
“0” setting. After the required amount of solvent has been set, press the key.
Make sure to have checked the compatibility of the solvent with the transmission.
- The cursor will automatically select “cleaning min.”. Press the key to set the required duration of the cleaning cycle. If you
are not going to perform any cleaning cycle, keep the “0” setting. After the required duration of the cleaning cycle has been
set, press the key.
Libretto 1885.indd 22
08/07/19 16:35
