HS-620/630 User Guide
- 7 –
QM14 Issue 4
2.6 Bearing Status Check
Fix the sensor directly to the bearing housing as close to the bearing as
possible. Note that valid high frequency readings are unlikely to be
measured using hand pressure and the spike.
Press the
BRG
key to enter the
Bearing Status
mode.
Press the
SEL
key to select either Bg (g RMS) or Bv (mm/s RMS).
When the bearing status reading has settled, press the
BRG
key to
enter the hold mode (
H
)
.
The bearing status reading is then held and the
rule-of-thumb alarm status displayed.
Press the
SEL
key to toggle through and select the appropriate speed
range of the bearing shaft. (rpm:<500, rpm:<1000, rpm:<2000,
rpm:<5000, rpm:<10000) .
The meter will then indicate either a tick icon for
OK
, a single bell for
vibration
alert
or two bells for
danger
.
The meter makes the assessment based on the rules-of-thumb defined
in section 4
2.7 Battery & Charger
The Vibration Meter is powered by an internal rechargeable Lithium-Ion
battery which can operate for 48 hours continuously following full
charge. The battery condition is indicated by an icon at the top right of
the meter display.
The battery charger supplied requires 3 hours to fully charge the battery.
An LED on the charger indicates the charge status, being orange when
charging and green when charging is complete.
Summary of Contents for Hansford Sensors HS-620
Page 3: ...HS 620 630 User Guide...