Beta Marine BetaGen 10, Installation Manual, Page: 86 / 116

84
SHUT DOWN ON FAULT
{
Problem Possible Cause and Solution
Low oil pressure shutdown - Oil pressure light illuminated: • Check the engine oil system for leaks & top up if required.
• Blocked lube oil filter, replace.
• Oil relief valve stuck partially open with dirt, remove and
clean.
• Faulty oil pressure switch.
High engine temperature shutdown - • Allow generating set to cool down. Check engine coolant
High engine temperature light, illuminated: level, top up appropriately, refer to ‘Filling the Engine
Coolant System’.
• Heat Exchanger, Header Tank or Radiator pressure cap,
check that it is not loose or faulty, replace cap should it be
required.
• High exhaust back pressure, must not exceed the stated
back pressure by 3” of Hg.
• Check/test the engine water temperature switch, if faulty
replace.
ENGINE START UP - PSM MODULE ONLY
{
Problem Possible Cause and Solution
PSM720 Only - Oil pressure light illuminated • Incorrect dip-switch settings. All dip-switches at the rear
of the module, bottom right hand side must be on the
‘ OFF ’ position.
• The green ‘ START ’ button has only pressed once, for
power up and preheat, the engine will not crank unless
it is pressed a second time and held for no more than
9 seconds.
70
Dip Switches